• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Temperature Gauge calibration

Share this page

W

wifegonnakillme

Jedi Hopeful
Offline
I was testing my temperature gauge with a kettle of boiling water last night. The resting temperature seems is on the notch between 90 and 185F, or about 135. If i put it in cold water it will go down a bit. Hot or near boiling water will make the needle climb up to and past 230F...
Is it possible to calibrate the gauge or is it better left to the professionals? I think it is necessary since the car has not been on the road for a number of years (in the body shop now) and I want to have faith that i'm not going to overheat it on the first run out.
Thanks in advance,
kerry /ubbthreads/images/graemlins/canpatriot.GIF

BTW I'm looking for reasonably priced amp and fuel gauges too if anyone knows a source (for a driver)
 
If it's a capillary (expansion bulb) type, leave it to the pros as the movement inside is a Bourdon Tube. If it's electric, you can calibrate the gauge yourself but it's tricky. Which do you have?
 
I think these gauges were fairly inaccurate when new, particularly at the extremes of their ranges. I suspect that is why they eventually dropped the numbers altogether.

I'd want to know where a 185 degree source reads on the gauge as that would be my 'normal', then consider what the gauge shows relative to that to spot overheating. The good news is that these gauges seem to be fairly accurate at normal operating temps.
 
Its capillary...figured i wouldn't be able to do it myself - will take the advice above and try to figure out a normal spot and then watch for deviation -
thanks,
Kerry
 
If you're going to try and make that type of calibration curve for your gauge, consider buying the Radio Shack (or other) infrared thermometer. Take a "dark" pan of boiling water and put the expansion bulb all the way in the bottom of it. Try to keep the bulb "off" the metal of the pan, only in the water. While the water is boiling make your first measurement with the IR thermometer (pointing it at the inner, wet surfaces of the pan). Turn off the heat and as the water cools make more measurements, comparing the gauge to your IR thermometer.

FWIW, I have a fairly new non-installed VDO capillary gauge and even it isn't precise when you get away from the 190-200 degree area. It's off by seven or more degrees when the water is "cold". A 30 to 40 year old Smiths/Jaeger instrument can be expected to have errors as Geo said.
 
Back
Top