• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Temp sending unit removal

Share this page

B

bucaneer

Member
Country flag
Offline
How do I remove the tempature guage sending unit from the block on my 67 BJ8. I have removed the large nut that holds the sensor in the block.
 
How do I remove the tempature guage sending unit from the block on my 67 BJ8. I have removed the large nut that holds the sensor in the block.

If you have done that it should just pullout be careful and wiggle it a bit.
 
Yep, be real careful pulling it out or you will break the soldered connection to the bulb and then it will not work any longer. If you have that happen, Nissonger can repair it for you.
Good luck,
Mike
 
Back
Top