-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Tail light wiring ???
- Thread starter rossco
- Start date
Share this page
bob hughes
Luke Skywalker
Offline
Rossco
Not completely sure about the 100 but on a 3000, if the wires get crossed i.e. put on a different way between the front and the rear lights then the indicator lights will act up, they tend to blip faster from memory, and they do not glow so brightly. They are at least side specific, so if the left side is fine and the wiring is mixed up only on the right side then only the right side will be affected. Does that help.
Bob
Not completely sure about the 100 but on a 3000, if the wires get crossed i.e. put on a different way between the front and the rear lights then the indicator lights will act up, they tend to blip faster from memory, and they do not glow so brightly. They are at least side specific, so if the left side is fine and the wiring is mixed up only on the right side then only the right side will be affected. Does that help.
Bob
bob hughes
Luke Skywalker
Offline
Rossco
Try checking a bulb against a battery and then determine which of the end points lights up which filament, with a 6/21 there must be a difference in illumination.
Bob
Try checking a bulb against a battery and then determine which of the end points lights up which filament, with a 6/21 there must be a difference in illumination.
Bob