Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
AUSMHLY
Yoda
Offline
The green Austin Healey 100/6 and 3000 workshop manual, General Data, page 15 states:
Synchromesh hubs: End float,
2nd speed, .007 in (.18mm)
3rd and 4th speeds, .031 in (.8mm)
It doesn't specify which model Healey.
I'm not up to speed on what that means.
How does one get that desired end float?
I'm only familiar with the laygear end float which uses thrust washers of different thicknesses to achieve the required end float of 0.012.
Synchromesh hubs: End float,
2nd speed, .007 in (.18mm)
3rd and 4th speeds, .031 in (.8mm)
It doesn't specify which model Healey.
I'm not up to speed on what that means.
How does one get that desired end float?
I'm only familiar with the laygear end float which uses thrust washers of different thicknesses to achieve the required end float of 0.012.
