• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

steering u-joints????

Share this page

T

trfourtune

Jedi Knight
Offline
has anyone replaced those rubber joints in the steering shaft connections with steel u-joints??? i'm looking for a source that will fit on the stock shafts with the correct splines. anyone?????anyone????? i already looked at borgeson but i don't think they are a match. /ubbthreads/images/graemlins/confused.gif /ubbthreads/images/graemlins/confused.gif /ubbthreads/images/graemlins/tongue.gif
rob
 
Just use the later TR6 lower ujoint (Moss #667-295) It should fit both upper and lower joint locations.

Oops, my bad - that only works if you have the earlier center column shaft that takes the bolt on fitting for the rubber donut. When I went back and looked at the catalog a second time, I saw where the TR6 at some point changed the shaft to have one of the brackets welded on.
 
Back
Top