Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
AHSquarebodySprt
Freshman Member
Offline
Alright so here were go.
I have been working on my Sprite for a LONG time.
Finally decided that i need to finish this project and got all my wiring done etc.
My ignition seems to have 3 positions.
Off > On > Ignition.
It doesn't feel like a traditional key where you turn it to start the engine and then when it cranks you let go and it goes back and the starter motor stops doing its thing.
When i put it in the 3rd position i hear the fuel pump clicking and then it stops however there isn't any starter motor action whatsoever.
So i ran a jumper right to the starter motor and there is absolutely nothing.
I can rotate the starter motor by hand and it isn't jammed however it will not spin at all.
Any thoughts?
I have been working on my Sprite for a LONG time.
Finally decided that i need to finish this project and got all my wiring done etc.
My ignition seems to have 3 positions.
Off > On > Ignition.
It doesn't feel like a traditional key where you turn it to start the engine and then when it cranks you let go and it goes back and the starter motor stops doing its thing.
When i put it in the 3rd position i hear the fuel pump clicking and then it stops however there isn't any starter motor action whatsoever.
So i ran a jumper right to the starter motor and there is absolutely nothing.
I can rotate the starter motor by hand and it isn't jammed however it will not spin at all.
Any thoughts?
