Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
nevets
Jedi Knight
Offline
Just a follow up on my previous post. As before, the car runs smooth and strong under acceleration but sputters/misses at a constant RPM, as when cruising in 3rd or 4th.
Things I’ve done: New points, plugs, condenser, rotor, and coil. Adjusted timing with timing light and it appears to be ok. Difficult to determine if it’s ignition related or carburetor related. Pulled a few plugs to judge whether it’s running rich or lean but after only 20 miles of driving, plugs are too new to tell a story. They are definitely not sooty or oily.
Watched the engine idle in a very dark garage and saw no arcing around dist cap or plug wires.
One thing I noticed is that the fabric insulation is frayed on the thin black wire inside the dist, not the ground wire, the other one. Sorry for being so vague in my terminology. And there is no felt oil plug in the top shaft, which there should be, according to NN’s tech briefs. My next step is to replace this wire and attempt to lightly lube the dist per the manual. Perhaps replace all the HT wires as well.
If the car is running too lean as someone suggested, could I test this theory by simply driving the car with the choke out slightly?
Any additional thoughts would be appreciated, thanks
Things I’ve done: New points, plugs, condenser, rotor, and coil. Adjusted timing with timing light and it appears to be ok. Difficult to determine if it’s ignition related or carburetor related. Pulled a few plugs to judge whether it’s running rich or lean but after only 20 miles of driving, plugs are too new to tell a story. They are definitely not sooty or oily.
Watched the engine idle in a very dark garage and saw no arcing around dist cap or plug wires.
One thing I noticed is that the fabric insulation is frayed on the thin black wire inside the dist, not the ground wire, the other one. Sorry for being so vague in my terminology. And there is no felt oil plug in the top shaft, which there should be, according to NN’s tech briefs. My next step is to replace this wire and attempt to lightly lube the dist per the manual. Perhaps replace all the HT wires as well.
If the car is running too lean as someone suggested, could I test this theory by simply driving the car with the choke out slightly?
Any additional thoughts would be appreciated, thanks
