Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Hello, I am new to the LBC car thing but am working on a 65 sprite. I have had some engine work done and am putting the engine back together. I have installed the crankshaft, camshaft, front plate and pistons connected to the crank. No timing gears installed yet. What I have ran into is that the #1 piston rod bearing cap is hitting the 2nd lobe on the camshaft. (the lobe for the #1 piston intake valve.) This just happens when the cam is in a certain position. I realize this may not happen when the timing gears are installed but am wondering if I have put something together wrong or what? Any ideas would be appreciated. Thank you, Mark
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
sprite engine trouble?
- Thread starter bjmk
- Start date
