• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Spring Compressor

Share this page

martx-5

martx-5

Yoda
Country flag
Offline
I'm about to redo the entire front suspension on my '59 TR-3 and have seen a rather simple threaded rod type spring compressor. Does anyone have any specs on this?? Length, size of plate on the bottom etc. I have a machine shop at work, so fabrication is no problem. I just need a picture or drawing.
 
I used a 24" threaded rod (1/2 or 5/8 ") with lots of washers and nuts at each end. For the plate, I found a 3 1/2" aluminum disk, about a 1/4" thick with about an inch-thick collar in the middle - don't remember where I found that. It worked well, but I do advise caution with this - no guarantees that it won't go flying apart! E-mail me if you need more info.

Mickey
 
Thanks Mickey,

That's sounds like what I had seen. The length of the rod and size of the plate were really what I needed.
 
I use 5/8 all thread rod. Since it is made of grade zip steel, do not expect to use it more than a few times. I use a little oil or grease on the rod so the nut will turn easier. Be Careful!
 
Back
Top