• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Speedo Drive Gear

Share this page

M

Merlin the MG

Freshman Member
Offline
Can anyone tell me where to plug into the transmission with the speedo drive cable? It's a '69 transmission on a '67 roadster. I've studied diagrams, but they're all blown apart so you can't really seem to find what hole to plug into. Thanks.

josey
 
If I remember right (can't go out to car, it's at the body shop)....it's further back from the clutch slave on the same side. There is an angle drive that attaches to the cable and screws into the tranny. Some people get a longer cable and successfully eliminate the angle drive, though I haven't done it myself. I did have to get the O.D. cable which is about 6 inches longer to eliminate binding and sharp corners behind the dash which wiped out two previous speedo cables.
 
The speedo drive is on the right (passenger) side of the transmission toward the rear. It is a white pastic fitting. If you have a 67B with a newer transmission you will need a angle drive. The tunnel on the 67B is to narrow to fit a OD cable to a non-OD transmission.

[ 04-16-2004: Message edited by: Jim 67B ]</p>
 
Back
Top