TexasKnucklehead
Jedi Knight
Offline
In another week or two, my head will be back from the head shop. A TR6 pressure plate and drawing to drill the flywheel is coming from Herman. I installed my crank in the block yesterday. I'm getting closer...
Does anyone have a spare set of 3/8" pushrods? My engine had 7 5/16, with only one bent, and 1 3/8. If I could buy a used set, I'd be happy. -well, I'm already happy, but I'd be happier if I didn't need to spend another $50.
Jer
On a side note, I noticed that my TR3-cost.xls had been at $12,xxx for some time. It was because the column addition was set to a line number a ways up. It's over $14. I liked it better when it was stuck.
Does anyone have a spare set of 3/8" pushrods? My engine had 7 5/16, with only one bent, and 1 3/8. If I could buy a used set, I'd be happy. -well, I'm already happy, but I'd be happier if I didn't need to spend another $50.
Jer
On a side note, I noticed that my TR3-cost.xls had been at $12,xxx for some time. It was because the column addition was set to a line number a ways up. It's over $14. I liked it better when it was stuck.