• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Someone have new floorpans not installed yet???

Share this page

F

fordtrucks4ever

Jedi Trainee
Country flag
Offline
If you happen to have one or the other side, could you measure the exact length. I would really appreciate it.
 
I am finally getting close to forming new pans and need to make sure of some measurements before preceeding. I would hate to be 1/4" off and then fudge everything to fit. There is enough new sheetmetal going to be replaced, that if one panel is wrong might cause a snowball effect.
 
Terry, I've got a set but won't be able to get to them to measure until after work tonight. I'll let you know after about 6pm EST, if you still need the measurements then.
Jeff
 
Measured a new yet to be installed set for a BE. 52" long. 18 5/8' wide at footwell. 22" wide at rear. The panel widens from 18 5/8" to 22" 15 3/8" back from the front of the footwell. Hope this helps.
 
Thats great. My donor parts are so far off from side to side, I needed a baseline to go with. You guys are becomming partly responsible for the work getting done...on "MY" car. Thanks
 
Back
Top