Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
jlaird
Great Pumpkin
Offline
The little fitting on the front carb that is the attachement for the vacumn advance 1/8 line.
Went all over no joy, but I had found a steel bolt that fit. So went to ACE and found a brass one that threaded in.
Drilled a 3/16 hole length wise through the bolt then cut it off and drilled in a bit from the other end 1/8 size and fitted a 1/8th copper tube and sodered it in. Ground the other end of the bolt to fit the bottom of the hole in the carb. Will use some teflon tape when I install it.
Why shucks, kind of a fun little job.
Oh and I note that the whole is only open when the butterflys are open. No advance at idle.
Went all over no joy, but I had found a steel bolt that fit. So went to ACE and found a brass one that threaded in.
Drilled a 3/16 hole length wise through the bolt then cut it off and drilled in a bit from the other end 1/8 size and fitted a 1/8th copper tube and sodered it in. Ground the other end of the bolt to fit the bottom of the hole in the carb. Will use some teflon tape when I install it.
Why shucks, kind of a fun little job.
Oh and I note that the whole is only open when the butterflys are open. No advance at idle.
