• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

slave cylinder resleeve or buy new

Share this page

T

tomnanney

Jedi Hopeful
Country flag
Offline
The clutch slave cylinder on my BJ 8 has gone out. It's been rebuilt several times through the years and I am wondering if it's time to have it sleeved or to just buy a new one. Are the ones from Moss or other suppliers worth buying? Any suggestions are appreciated.
 
tomnanney said:
The clutch slave cylinder on my BJ 8 has gone out. It's been rebuilt several times through the years and I am wondering if it's time to have it sleeved

Good Idea and double stepped machined by Billy @ White Post Restorations---Keoke


or to just buy a new one. Are the ones from Moss or other suppliers worth buying?

Well IMOP: Wont stand up to a properly rebuilt one

Any suggestions are appreciated.
Click to expand...


--------------------------------------- :driving:
 
I had Apple Hydraulics in New York rebuild my two master cylinders with sleeves installed. The cost was significantly lower than White Post and they are holding up just fine.
 
Back
Top