Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Just removed my clutch slave cylinder and discovered my repair kit pieces look too small. This is a delphi cylinder that was on it. Also found the clutch arm boot was disintegrated.
What is the correct size for the 66 sprite 1098 and should I just replace this with the correct one rather than trying to rebuild?
I have had the master resleeved to its original 3/4 as the PO had put in a 7/8 replacement at some point.
What is the correct size for the 66 sprite 1098 and should I just replace this with the correct one rather than trying to rebuild?
I have had the master resleeved to its original 3/4 as the PO had put in a 7/8 replacement at some point.
