• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

SKF Speedi-sleeve p/n for tailend of transmission?

Share this page

T

TuffTR250

Jedi Warrior
Country flag
Offline
Can someone tell me the SKF part number for the Speedi-sleeve that will fit the flange on the rear end extension of a TR3/TR4 transmission? Thanks!

I've replaced the transmission rear extension oil seal, but the flange piece has a little bit of a groove in it so I thought I'd better fix that before I put it back on.
Regards,
Bob
 
Think it might be this:

NATIONAL Part # 99168 More Information About this Part Redi-Sleeve; Shaft Size Min=1.684", Shaft Size Max=1.69", Width=0.563", Overall Width=0.688", Flange Outer Diameter=1.906",

That's what Rockauto lists for a TR6 gearbox, should work as well for TR3/4 but you'd want to measure I think to make sure.
 
Great! Thanks for the quick reply!

p.s. I checked at Moss web site and TR3 thru TR6 all have the same p/n for the flange, so I think a Speedi-sleeve for TR6 would fit TR3/TR4.
Regards,
Bob
 
Thanks again Randy! I went ahead and ordered the SKF p/n 99168 from RockAuto. It had almost the exact same specs as the National and I've had good luck with SKF sleeves in the past. I measured my flange and it measured within the specs of both National and SKF sleeve p/n's 99168.
Regards,
Bob
 
Back
Top