• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Shorty Toneau cover for Jack

Share this page

drooartz

drooartz

Moderator
Staff member
Gold
Offline
Jack -- this is what I have. Is this what you need? There is one small tear on the passenger side, about an inch or so long. Probably could be mended.
 

Attachments

  • 4102-toneau.JPG
    4102-toneau.JPG
    27.8 KB · Views: 77
That's the one, and yep rip can be minded for sure.
 
I'll box it up tonight, should go out in the mail in a day or two.
 
Drew if you havn't already boxed the tonneau up, can you take set of reasonably accurate measurements and some more pics? I'd like to make one, it'd be a good project for the cold months.

I've been looking at ncbugeye and was wondering what purpose the two cutouts serve. There doesn't seem to be any part that has to be cleared at that point just behind the edge of the windscreen. Any idea?

Also if anyone else has a "long" form tonneau please take measurements of that and post pics too.

Please, pretty please.
 
Chris - it's already boxed up and ready to go out in the mail tomorrow. I'm sure Jack will be willing to measure it up for you when it arrives in FL.

Don't know what those cutouts are for, either. I put it on Tunebug and it did seem to fit but those details seemed to be extra. I guess we'll see when Jack gets it installed on Ms Agatha.
 
Aren't those cutouts for the roll bar?
Bill

Looking at it again I think that I am looking at it backwards!! That is a strange looking tonneau!
Bill
 
Hehe, when it arrives I will take a photo and measure and post.
 
Drew's pic is taken with the front of the tonneau at the top of the picture - you can see the pocket for the top of the steering wheel at top left. Also the zipper zips from the front.
 
The cut-outs are for going around the windshield stanchions. Remember, the sides hang over the door at least a couple of inches on the sides, and go pretty much to the windshield base across the front! I do remember the original on my old one was not as square at the back though, following the radius of the rear corners of the cockpit somewhat to snaps across the back!
 
Back
Top