Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
So I bought new floor pans and have put them in but I now need to locate the seat tracks and my pans do not have any holes. I have located one spot to place them but I am fearful that it to far to the rear of the car. Can anybody give me some measurements or a source as to where to drill. It is a puzzle. Now I know why the pans were cheaper! Ha
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR6 seat track location on new pans without holes for seats
- Thread starter JWDH
- Start date
Share this page
Offline
I faced this problem too, not long ago. The seats bolt into reinforced nuts on the underside of the floor. Several of those nuts have to fit into holes in the frame. I doubted that I could get the holes for the seat mounts located accurately enough to guarantee that they would go into the frame holes, and if they were off, it would be quite a problem. Instead, I made mounts that were welded to the floor; here's the story of what I did:
http://tr4a.nonlintec.com/bodywork2/#seat_mounts
http://tr4a.nonlintec.com/bodywork2/#seat_mounts