• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A Seat position

Share this page

A

Arrow

Senior Member
Country flag
Offline
I installed new floor pans in TR3A, seat track holes were pre-drilled. Seats installed are now slightly turned outward and not straight. Is this correct or do the seats sit perfectly straight in the car? I pulled a string from door jam to door jam and the ridges on the seat bottoms are turned about 1/2 inch.





BE0FD575-46E9-48E3-8E8E-32F6424DAD2F.jpeg
 

Attachments

  • Passenger seat 2.jpg
    Passenger seat 2.jpg
    1.9 MB · Views: 169
Last edited:
I am not sure? I think it falls into the category of accepting those things that cannot be (easily) changed. In other words, it is not worth replacing or re-drilling the floors...unless the seat travel is restricted on adjustment.
 
I will not need to look closer, but I was thinking maybe they are that way to make room for the removable trans tunnel because that bells out. If they were tapered in, then they would hit the tunnel early in their travel.

steve
 
Back
Top