Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
klutterbutt
Member
Offline
Hi everyone,
I've searched out and read the previous postings on this topic but I didn't find any comments about how to finish installing the covers. First, let me say that I didn't have the advantage of being able to refer to the old seat covering as a guide in the installation of my new covers. My 66 MGB came with much later seats of the headrest type but covered in slip-on fuzzy sheep-skins. Even the foams were sitting directly on the floor.
I had no trouble getting the replacement covers on the restored 66 frames I bought. I installed new foams and diaphrams and slipped the covers (from Moss) on. I can see how to attach the bottom covers with the clips to the frame (not sure how tight to pull it though) but I can't figure out how to finish off the hanging bits of material and piping at the bottom of the seat back and the back of the seat bottom. Also, I need to know if the pivot bolt threads from the inside out or from the outside in. I thought I had purchased all the right books on restoration but none that I have cover this installation.
If anyone can direct me to a web site that has detailed installation instructions (w/pictures) or just tell me how to go about finishing off the installation I'd really appreciate it.
I've just been retired from the school district I worked for and will have more time to work on my two project cars. So, you can expect to be challenged with many stupid questions over the course of time it takes me to make these cars streetable again. I promise all of you that I will listen and learn from all the very valuable bits of knowledge you share with each other on this forum. I might even share a bit of knowledge myself.
Thanks in advance for any help you might offer up.
Jim C
1966 MGB
1973 Midget
I've searched out and read the previous postings on this topic but I didn't find any comments about how to finish installing the covers. First, let me say that I didn't have the advantage of being able to refer to the old seat covering as a guide in the installation of my new covers. My 66 MGB came with much later seats of the headrest type but covered in slip-on fuzzy sheep-skins. Even the foams were sitting directly on the floor.
I had no trouble getting the replacement covers on the restored 66 frames I bought. I installed new foams and diaphrams and slipped the covers (from Moss) on. I can see how to attach the bottom covers with the clips to the frame (not sure how tight to pull it though) but I can't figure out how to finish off the hanging bits of material and piping at the bottom of the seat back and the back of the seat bottom. Also, I need to know if the pivot bolt threads from the inside out or from the outside in. I thought I had purchased all the right books on restoration but none that I have cover this installation.
If anyone can direct me to a web site that has detailed installation instructions (w/pictures) or just tell me how to go about finishing off the installation I'd really appreciate it.
I've just been retired from the school district I worked for and will have more time to work on my two project cars. So, you can expect to be challenged with many stupid questions over the course of time it takes me to make these cars streetable again. I promise all of you that I will listen and learn from all the very valuable bits of knowledge you share with each other on this forum. I might even share a bit of knowledge myself.
Thanks in advance for any help you might offer up.
Jim C
1966 MGB
1973 Midget