• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Seat Belt Problem

Share this page

mdionne

mdionne

Member
Offline
After removing the seat belts over a year ago and doing tons of work, I am now ready to install new seat belts. Except..........can't find the dang attachment point for end piece coming out of the recoil. I have the buckle attached to the tunnel and the recoil attached behind the seat. Where the heck does the other bolt go?

I have just put in all new interior and do not want to rip it all out. So I'm ripping my hair out instead/ Help please!
 
Mike, assuming this is a Midget (and you may want to take this to the Spridget (Sprite+ Midget board) You should have three points. The "female" end on the tunnel. The Belt recoil piece behind the headrest and the third straight below that beside the seat base. Then when you pull the belt, it does both the waist and the shoulder belt. Hope that makes sense, I can get a picture if you need it.
 
Thanks everyone! Found em! Right where Ron says they're supposed to be. Only I filled them in with sealer after I welded in new floor pans. Must have said, "Sure I'll remember what those are for and where they are". Said that a lot before I started taking digital photos of everything I dismantle and re-assemble!

Thanks again!
 
Back
Top