• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Scuttle Vent Rubber placement

Share this page

PatGalvin

PatGalvin

Jedi Warrior
Offline
How does the rubber fit under the Scuttle Vent? Does anyone have a photo for this? Or can describe how the rubber seal fits under this vent? Thanks

pat
 
There is a vertical lip all around the recessed area below the outer vent cover plate and the slot in the seal sits down (over) this vertical lip. You will have to remove the two springs and all the interferring bits (screws, clips and pins) that are preventing you from installing the new seal.
 
Also, a tab on the seal goes under the vent hinge screws...although I wound up cutting that tab off to lower the vent enough to fare with the scuttle top.

John
 
Back
Top