• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

RPM / TACH not working.

Share this page

Mowgli81

Mowgli81

Member
Offline
BJ8 3000 MKIII
RPM gauge not working. Put tach-meter on coil and getting reading. Nothing at the Tach gauge itself. I know the previous owner took apart dash and reinstalled. I have wiring diagram for vehicle.
What I'm looking for if anyone has is:
  1. A picture of the gauge hooked up? so that I can verify some wiring (looks rigged)
  2. Some good instructions on troubleshooting or installation?
  3. Thoughts on common problems

    Thank you in advance guys.

    Greg
 
First if it was converted to negative ground you have to change the capiciter inside the unit also the white wire loop needs to be changed there are a number of articles on the net about this
 
The vehicle is still a positive earth.
 
see if the wiring is correct then look at the b/w wire at the cut off switch and clean connections at the coil
 
I'll help anyone named Greg.
tach.JPG
 
Back
Top