Roll [ over] Bars

[tiga2]

Does anybody build a "stock" roll over bar for a 1004 or know where one could be had new or used? I am in a place where things like this are difficult to get made, to say the least?

Thanks!

 

[Randy Forbes]

I made my own, as there was nothing readily available for the 6 cyl/two-seaters either.

 

[bighly]

I think your best bet is a race car fabricator. I just went thorough this on a car I am involved in building. After looking high and low all we could find was "light duty" premade bolt ins. Check you local area for roll bar and race car fabricators.

 

[roscoe]

Taiga2,
Try Joe Huffaker, at Huffaker Engineering. 707 935 0533.
Hey, what's a taiga... is that a tiger from Boston?

 

[tiga2]

...This is a TIGA (#2), not a Taiga. But I will try Huffaker, I know those guys, as Sears was my home track for 12 years.

Thanks.

 

[Randy Forbes]

Finally decided to make a new rollbar that would fit under the Healey's soft top.

I've had the bender for a year, and had ordered double the amount of 4130 1-1/2 x .120 tube I'd need to build a rollbar for a customer's M Coupe.

The main component:

Getting started:

Helpful aid:

And what it allows:

Looking good:

Details:

All the pictures can be seen at: https://www.rfdm.com/gallery/album113 Most of the pictures can be clicked on once open to see a higher resolution image.