• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Rocker shaft dis/reassembly

Share this page

Moseso

Moseso

Jedi Knight
Offline
The alloy pedestals on the four cyl. motors are a real tight fit on the shaft. Is one advised to heat them when removing/reinstalling them on a rocker shaft rebuild -- or just twist 'em off and on?
 
I've always just twisted mine. Don't suppose a little heat would hurt, though, I've just never seen the need.
 
Got to be careful with heat around aluminum. Melts pretty low. Like Randall, I just twisted mine on and off. The shaft doesnt move in the pedestals. Might put some WD-40 in there to assist with the twisting.

Good Luck, Tinkerman
 
Twist. I reassembled mine with Lucas Oil Stabilizer. It wasn't fun to work with, but everything was well lubed when finished.
 
Back
Top