Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
If I choose to replace my orig. smoot case tranny with a ribcase unit what mods do I have to make? Clutch? flywheel ? drive shaft?
Thanks
W French
Frenchww@aol.com
Thanks
W French
Frenchww@aol.com
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Ribbed case tranny in 948 bugeye
- Thread starter Frenchww
- Start date
Share this page
Gerard
Luke Skywalker
Offline
You'll need the thicker cast steel backplate from a later engine. Review the page at the link below. It should answer all your questions.
https://gerardsgarage.com/Garage/Tech/TO_Bearings/tobearings.htm
https://gerardsgarage.com/Garage/Tech/TO_Bearings/tobearings.htm
Tomchillvet
Freshman Member
Offline
newbe here---i don't know why i can't get it straight in my head about gerards post - putting a ribcase on a 948- can someone explain what needs to be done to get the ribcase to work on the 948- can i use the 948 clutch,fork,throwout bearing,flywheel or some combination of both that will work with the 1275 backing plate- sorry but don't want to get wrong parts--thanks