Good afternoon chaps. Has anyone with a RHD BJ8 any details of the length of the connecting rods for the throttle controls?
I have converted L to RHD and the setup needs new rods. The manual just shows a LHD arrangement.
If anyone could supply approx measurements ball joint to ball joint, that would be most helpful as a starting point as the threaded rods available have to be cut to length from scratch.
Thanks in anticipation.
Regards Al
I have converted L to RHD and the setup needs new rods. The manual just shows a LHD arrangement.
If anyone could supply approx measurements ball joint to ball joint, that would be most helpful as a starting point as the threaded rods available have to be cut to length from scratch.
Thanks in anticipation.
Regards Al
Last edited by a moderator: