Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
YesIstillhavethe
Freshman Member
Offline
What should I do with the inside bottom return bend on each side of the front shroud? From what my feeble research has shown, there may not the same shape from one side to the other.
So
Is the lip that goes back up on the back side of the front shroud at the bottom on each side nice and neat and a uniform shape across? Or is it kinda wavy and looking like it was hand formed and since it is on the back side and the bottom, maybe the panel beater didn't take any extra time to make it uniform?
Thanks everyone. I have had this car for 42 years and FINALLY restoring it. It was my daily driver back in 69. Your vast collective wisdom is greatly appreciated.
So
Is the lip that goes back up on the back side of the front shroud at the bottom on each side nice and neat and a uniform shape across? Or is it kinda wavy and looking like it was hand formed and since it is on the back side and the bottom, maybe the panel beater didn't take any extra time to make it uniform?
Thanks everyone. I have had this car for 42 years and FINALLY restoring it. It was my daily driver back in 69. Your vast collective wisdom is greatly appreciated.
