YesIstillhavethe
Freshman Member
Offline
What should I do with the inside bottom return bend on each side of the front shroud? From what my feeble research has shown, there may not the same shape from one side to the other.
So
Is the lip that goes back up on the back side of the front shroud at the bottom on each side nice and neat and a uniform shape across? Or is it kinda wavy and looking like it was hand formed and since it is on the back side and the bottom, maybe the panel beater didn't take any extra time to make it uniform?
Thanks everyone. I have had this car for 42 years and FINALLY restoring it. It was my daily driver back in 69. Your vast collective wisdom is greatly appreciated.
So
Is the lip that goes back up on the back side of the front shroud at the bottom on each side nice and neat and a uniform shape across? Or is it kinda wavy and looking like it was hand formed and since it is on the back side and the bottom, maybe the panel beater didn't take any extra time to make it uniform?
Thanks everyone. I have had this car for 42 years and FINALLY restoring it. It was my daily driver back in 69. Your vast collective wisdom is greatly appreciated.