• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Replacing studs

Share this page

drooartz

drooartz

Moderator
Staff member
Gold
Country flag
Offline
Since I'm in the process of rebuilding front and rear suspension and switching over to discs, should I plan to replace all the wheel studs while I'm in there? How do I go about doing that?
 
Replacing the studs is easy. Just knock the old ones out with a hammer, and put the new ones in place. You can press them in from the back, or take an old lug nut, reverse it so the flat is facing the hub, and use your impact wrench to pull the stud in from the outside.
It's your call on whether to replace them or not.
Jeff
 
Back
Top