• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Replacing steering box seal

Share this page

Dave Russell

Dave Russell

Yoda - R.I.P
Gold
Offline
I just replaced the seal on my BN2 steering box. Have read about the problems getting the pitman arm off.

With the proper tool, I was able to get the arm off without moving or loosening the steering box at all. It just slipped into the joint from the wheel side & popped the arm right off.

The puller is Stahlwille #12616, code 71050000. See attached pic.

Nice to not have any leaks now.
D
 

Attachments

  • 202761-DSC00819.JPG
    202761-DSC00819.JPG
    146.7 KB · Views: 197
Hi Dave,

Thanks for the tech tip. I know others have asked if this is possible (replace seal with box in car) so it's good to know it can be done!

I assume you didn't have to replace the steering box bushing?

What kind/weight of oil did you end up using for the steering box?

Cheers,
John
 
Hi John,
The bushing is nice & tight. Well lubed, as I kept filling the box as it slowly drained. I use SAE 80W90 GL4 gear oil. Nice to not have it self changing anymore. I also got a new seal for the idler, but it has never leaked yet.
Regards,
Dave
 
Back
Top