-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR4/4A Replacing inner furrey window glass seals.
- Thread starter malbaby
- Start date
Share this page
trrdster2000
Luke Skywalker
Offline
Clips on the door, hold with a bent piece of metal to cup it and push the rubber seal into it. The metal gripper will need to be thin, the front ones get tight. Also make sure they are lined with the indention in the seal.
Wayne
Wayne
Mal
agree with Wayne
just re -did the outers on my TR4 and found that holding the clip on the tool with blutack and then just positioning it on the door and the trim at the same time worked. I got them all in place then went through and closed them off by pulling up on the tool while firmly holding the trim down.
I found that the clips I had needed to be "opened" out enough to get the initial set on the door.
hope all that makes sense
graze
Geo Hahn
Yoda
Offline
The answers seem to be about the rubber seal rather than the furry -- but perhaps the technique is similar.
The 'tool' mentioned can be made from an old hacksaw blade though this item also works well and has a more comfortable handle:
https://www.lowes.com/pd_76781-47120-SGY-TOOL2_0__?productId=3361552&Ntt=
The 'tool' mentioned can be made from an old hacksaw blade though this item also works well and has a more comfortable handle:
https://www.lowes.com/pd_76781-47120-SGY-TOOL2_0__?productId=3361552&Ntt=
Thanks guys...
Replaced the inners this morning... opened the clips up slightly as suggested ....found that I had to put the clips that I had onto the seal first... then got the seal started at one end and carefully moved along with the tool that I made until I had all the clips started on the channel and then progressively pulled them up tight.
Replaced the inners this morning... opened the clips up slightly as suggested ....found that I had to put the clips that I had onto the seal first... then got the seal started at one end and carefully moved along with the tool that I made until I had all the clips started on the channel and then progressively pulled them up tight.