• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

MGB replacing 1976 MGB ignition

Share this page

B

bubbarus

Freshman Member
Offline
Hey guys. Since my last post I have decided to replace the aftermarket ignition box with a pertronix kit. While I'm at it, I want to replace all components associated with the ignition. My question is, with the pertronix ignition, what type of coil and condenser and ballast resistor (if required) should I install? The engine is stock except for carb (webber). Thanks for your help.
 
I have the Pertronix Ignitor in my 78B and one of Pertronix’s flamethrower Coils. Just make sure you get the correct coil for your application. I still have the stock ballast resistor in my car so I stayed with the lower resistance coil. If you don’t know what you have you can actually measure the resistance across the coil with a mulit-meter set on the ohms setting.

Example: 1.5 Ohms Ballast Coil vs. 3.0 Ohms no ballast.

Also look over your plugs, rotor, rotor cap and plug wires. I upgraded all of mine to handle the hotter coil and slightly increased the plug gap.

I never saw any real performance improvements. But she turns over on cold mornings really easy now.

Good luck,
 
Back
Top