Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Gatheringtree
Senior Member
Offline
The headlamp bezel on my 1960 Triumph TR3A has no screws. I found that there is a pressure latching point at the 5 o'clock position on the bezel. I used a curved plastic bicycle tire removal tool to attach to the bezel rim. I discovered that a simple pry with hardly any pressure would snap the bezel loose. Any curved device or tool would do the same job.
Prior to discovering this I was trying, with great effort to pull the bezel off with my hands place on either side, and I could not get it off.
I inserted the curved tool in the 5 o'clock position as shown here. I pressed the tool toward the headlamp to pry the bezel off.
I was surprised how little effort it took for it to snap loose.
Prior to discovering this I was trying, with great effort to pull the bezel off with my hands place on either side, and I could not get it off.
I inserted the curved tool in the 5 o'clock position as shown here. I pressed the tool toward the headlamp to pry the bezel off.
I was surprised how little effort it took for it to snap loose.
