• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Relocating the coil for an alternator

Share this page

M

mylesw

Jedi Hopeful
Offline
Hello

Can someone let me know where I put the coil when I convert to an alternator on my BT7?

Thanks

Myles
 
There are plenty of options; I at one time had mine on the RH toe-board (LHD car) above and to the outboard side of the starter solenoid.

Currently, my MSD coil is mounted in the narrow channel on top of the RH toe-board.

The RH inner fender is another likely possibility.
 
Hi Myles,

As Randy indicated, it is possible to mount your coil in a number of nearby places. My initial placement was with homemade brackets on top of the Delco alternator, however, I settled upon a location that put the coil out of the main flow.

100_0266.jpg



Since I had previously mounted my CD ignition (Crane) box on the passenger foot well end plate, the platform I constructed to accept the also allowed me to hide the CD and coil wiring below to make the area look a lot cleaner. I was told that the coil should be mounted vertically with wire from the top.

Although I have a 40K replacement, the original coil is still good after forty years being mounted horizontally, so I am not sure the advice is that important to follow. So far so good.

Good luck,
Ray (64BJ8P1)
 
Back
Top