Rear fender install[100/6]

[Bob Claffie]

So far, so good. For each side a small bag with 8 small countersunk head machine screws, nuts and washers, 2 phillips head machine screws with washers and nuts, one sheet metal screw. What goes where? Fairly sure where the countersunk screws go the others are a mystery. Thanks, Bob

 

[Keoke]

So far, so good. For each side a small bag with 8 small countersunk head machine screws, nuts and washers,----Behind shutface panel at rear of door.

2 phillips head machine screws with washers and nuts,----Bottom of Dogleg just aft of rear door gap in Cill.

one sheet metal screw.---Just about the center of the dog leg installed facing up.--But if it was me I would forget it. /bcforum/images/%%GRAEMLIN_URL%%/grin.gif

What goes where? Fairly sure where the countersunk screws go the others are a mystery. Thanks, Bob

------------------------Keoke--- /bcforum/images/%%GRAEMLIN_URL%%/cowboy.gif

 

[Bob Claffie]

Thanks, when I trial fitted the wings I didn't have the correct hardware so I hogged out the holes at the bottom of the dog legs and used 1/2-20's. Now the "correct" screws look much too small. At least now I know. I agree on the sheet metal screw, who needs it? Not me. Bob

 

[Keoke]

Thanks, when I trial fitted the wings I didn't have the correct hardware so I hogged out the holes at the bottom of the dog legs and used 1/2-20's. Now the "correct" screws look much too small.-----Yep

But maybe you can make up "D" washers to cover you goof At least now I know.

I agree on the sheet metal screw, who needs it? Not me. Bob

I aint got em either--------------Keoke-- /bcforum/images/%%GRAEMLIN_URL%%/laugh.gif