• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A Rear bumper bolts size/thread?

Share this page

Jim_Stevens

Jim_Stevens

Jedi Warrior
Gold
Country flag
Offline
Looking for the rear bumper support spring attachment size and thread. The long one that goes through the spacer tube. I can’t seem to find the old ones. (Guess I’m not as organized as I should’ve been?). Anyways, it’s Moss part 322-185. I was hoping to get a couple of stainless ones instead.

Any help appreciated! Jim
 
Looking up the Moss part number you listed I found the link below which fully describes the length, diameter, and pitch.'

https://mossmotors.com/hex-head-bolt-3-8-24-x-5-1-2-unf

You may find similar bolts locally in stainless... perhaps 6" that have to be cut down in length a bit. Alternatively you could probably buy a small box of them from a place like McMaster-Carr (mcmaster.com)
 
dklawson said:
Looking up the Moss part number you listed I found the link below which fully describes the length, diameter, and pitch.'

https://mossmotors.com/hex-head-bolt-3-8-24-x-5-1-2-unf

You may find similar bolts locally in stainless... perhaps 6" that have to be cut down in length a bit. Alternatively you could probably buy a small box of them from a place like McMaster-Carr (mcmaster.com)
Click to expand...

Wow! That’s a handy little link. Thanks— Jim
 
In the Moss site search bar you have to put "Hex Head Bolt" and it brings up a list with the size and the Moss number. If you put in the number you just get the price and where it is used.

David
 
Back
Top