Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Hi all, I have spent some time looking for information on my problem. I used the Moss rear brake kit to rebuild the rear brakes on my 60 bt7. Drums were machined at a local shop. Right drum went on and turned with the ebrake connected. Left drum went on and turned until I reconnected the ebrake at the wheel. This connection was tight enough to activate the brake so that I could not turn the drum by hand. All adjusters are completely backed out. Cannot think of why one side would be fine and the other too tight. Can I simply adjust the ebrake to put some slack in the system? It may be a day or two before I get back to check on this so please bear with me. Thanks.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
rear brake drum too tight after rebuild
- Thread starter ah60_68
- Start date