• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
  • When posting a classified ad, you MUST select a prefix from the drop-down next to the subject line. If you don't you will get an error and your ad will not be posted!
Tips
Tips

Re-assembly progress and a wiper rack question

Share this page

64rocksprite

64rocksprite

Jedi Trainee
Country flag
Offline
Hey all..need a quick check..
I re-installed the wiper rack last night..and it seemed to want to go above that stiffener that runs from the firewall to the edge of the cowl. Is this correct? MKII Sprite.
BTW..here are some pics of recent 'steps'..I got my Maniflow back from JetHot. I like how it looks! Lifetime warranty too.

Also finally got around to cutting/welding the shift lever for the 5-speed.
I'm thinking if I post progress...I'll have to make a little bit each week!
 

Attachments

  • 12-9-12 010_small.jpg
    12-9-12 010_small.jpg
    91.7 KB · Views: 125
  • 12-9-12 005_shiftersmall.jpg
    12-9-12 005_shiftersmall.jpg
    61.4 KB · Views: 127
  • 12-9-12 006_shiftcover_sm.jpg
    12-9-12 006_shiftcover_sm.jpg
    63.1 KB · Views: 129
I like the RED. Which Red are you using?
 
Here is the routing on my bugeye. It's likely the same on your car.

Jim
 

Attachments

  • IMG_5395 small.jpg
    IMG_5395 small.jpg
    95.9 KB · Views: 130
Many thanks JJ, that's where it is on mine. I just couldn't remember.

JimG - Thanks - The shift cover is Kirker's SS urethane - "Snake Red" (Viper red I would assume).
 
You may find that even with the shift lever mods that the original shift cover and boot will not work. I sectioned my cover about an inch. Still looks stock and lets the shifter work.

Kurt.
 
Kurt - Do you have a picture of your section work? I'm assuming you added width (left to right)? What did you use for a boot with that section? It does look like the boot is stressed out in 1st and 5th..
 
Isn't that where an MGB Boot is sometimes used instead?
 
64rocksprite said:
Kurt - Do you have a picture of your section work? I'm assuming you added width (left to right)? What did you use for a boot with that section? It does look like the boot is stressed out in 1st and 5th..
Click to expand...

By sectioning it I meant that I cut about an inch out of the height of the cover. I cut the cover right at the flange then cut a section out and rewelded the flange. That made the cover look pretty much the same but since it wasn't as high it doesn't interfeer with the shifter as much.

Kurt.
 
Ah...that makes more sense..I wasn't thinking in that 3rd dimension! That is a good idea.
I hate to cut it after I just shot it with new paint! I may not have a choice though..I'll regret it later if I don't. I have some misc parts to paint yet..roll bar, sway bar,..and now shift cover!
Just when you think you can pack up the welder....it pulls you back in! :rolleyes2:

Thanks for the suggestion Kurt
 
Back
Top