• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Question regards headlight ring 'thickness' for bugeye

Share this page

T

twas_brillig

Jedi Knight
Country flag
Offline
I've got one chromed headlight ring that is 1 5/16 'deep' and fits the buckets etc. that I've got, plus two other rings that shallower, at slightly less than 1" deep and don't fit the headlight buckets in the bonnet.

Can anyone advise as to which is the proper ring? If it's the 1 5/16, then I buy one more; if it's the 1", then I purchase two inner ring assemblies.

Thanks, Doug
 
The correct one, if original, will have a screw hole in the bottom, just off center. It will match the hole in the bonnet under and forward of the headlight bucket. They also have a brass rivet, top dead center.
 
I've got three different 'thicknesses' of headlight chromed rims; AH Spares advised that there's are 1 inch thick, and those are the ones we've installed. Which are just as Gerard described. Now where in heck the other ones came from is a bit of a mystery. Thanks Gerard! Later, Doug
 
Glad you have the right ones.

Did you ever get my email about the shifter?


twas_brillig said:
I've got three different 'thicknesses' of headlight chromed rims; AH Spares advised that there's are 1 inch thick, and those are the ones we've installed. Which are just as Gerard described. Now where in heck the other ones came from is a bit of a mystery. Thanks Gerard! Later, Doug
Click to expand...
 
Back
Top