• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Question for Jeb...[or anyone who can answer]

Share this page

Basil

Basil

Administrator
Staff member
Boss
Online
(Mike had posted this in the guest book, so I took the liberty of reposting it here - Basil)

Hi,
I've got a question for Jeb. I feel like I know you Jeb. I've been on the e-type lovers list for several years and have read a lot of your informative as well as humorous posts. I have a '70 FHC waiting in the wings while I finish up my '80 MGB and my '79 MGB LE. On my '79 the choke was not working. Upon disassembly I found the small brass piston to be frozen in place. I damged it while trying to dislodge it. Anyway, I found a replacement and decided while I was there that I'd convert to a manual choke. I've completed the installation , but have only partial choking.When I installed the brass piston I was unsure of the alignment of the holes in the piston and those in the body of the carb.What do you think?
Godspeed,
Mike
 
Originally posted by Basil:
(Mike had posted this in the guest book, so I took the liberty of reposting it here - Basil)

Hi,
I've got a question for Jeb. I feel like I know you Jeb. I've been on the e-type lovers list for several years and have read a lot of your informative as well as humorous posts. I have a '70 FHC waiting in the wings while I finish up my '80 MGB and my '79 MGB LE. On my '79 the choke was not working. Upon disassembly I found the small brass piston to be frozen in place. I damged it while trying to dislodge it. Anyway, I found a replacement and decided while I was there that I'd convert to a manual choke. I've completed the installation , but have only partial choking.When I installed the brass piston I was unsure of the alignment of the holes in the piston and those in the body of the carb.What do you think?
Godspeed,
Mike
Click to expand...

Mike,
The position of the sliding valve or piston as you call it is not subect to alignment problems due to the overlapping lever which "meshes" with the valve. If you are only getting partial operation go back and make sure that you have followed the manufacturers instructions for the cable installation. I'll admit it is a bit obtuse.
Make sure that the tiny little o-ring at the tapered end of the valve is in good condition. Also make sure that you have not over-opened the idle adjusting air bleed screw. This may limit the vacuum action at the choke body.
Dave


------------------
 
Back
Top