• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Propshaft length - Toyota 5 speed conversion

Share this page

B

BBH

Senior Member
Offline
I am looking for the prop shaft length, for a 3000 with a Toyota 5 speed conversion. I have the Toyota gearbox fitting and my original props haft and need to combine the 2 for the re-build.
 
BBH said:
I am looking for the prop shaft length, for a 3000 with a Toyota 5 speed conversion. I have the Toyota gearbox fitting and my original props haft and need to combine the 2 for the re-build.
Click to expand...

I was going to do that but the driveshaft shop said it was easier just to make a new shaft from scratch.

Notes I made in the Smitty manual at the time:
PropShaftToyDimensionsParts.JPG
Note: the 20-3/16" includes the 3/4" deduction for clearance when the yoke slides in and out.

Caveat added: it would be better to mount your tranny then measure the distance between the axle flange and rear of the trans then have the shop compensate for that. Smitty's instructions said to allow 3/4" for yoke movement.
 
Last edited:
Steve, I think you are right. I'll get a new one made up once every-thing else is installed so that I can get as fitted sizes.
 
Back
Top