Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Tinkerman
Darth Vader
Offline
As some of you may have seen, I got the engine of my TR3A running today, YEA!
However it doesn't run above an idle speed. When I flip the linkage over to (what I would think would be a higher speed)nothing happens. It remains at a low speed. In other words I get no acceleration out of my engine. What did I do wrong? What would make that happen? I have new throttle bushings on the carbs. (SU H6) but it just will not accelerate. I put the carbs back together and followed all the steps in the SU carb workshop manual. I messed something up, probably, but what? How do I trouble shoot the problem?
Any thoughts or suggestions greatfully accepted!
Tinkerman
However it doesn't run above an idle speed. When I flip the linkage over to (what I would think would be a higher speed)nothing happens. It remains at a low speed. In other words I get no acceleration out of my engine. What did I do wrong? What would make that happen? I have new throttle bushings on the carbs. (SU H6) but it just will not accelerate. I put the carbs back together and followed all the steps in the SU carb workshop manual. I messed something up, probably, but what? How do I trouble shoot the problem?
Any thoughts or suggestions greatfully accepted!
Tinkerman
