-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Primary Ballast Resistor Ignition?
- Thread starter RichC
- Start date
Share this page
Offline
Hi Rich,
If your 75 is still stock, it uses a resistance wire in the harness & a 6 volt coil. There should two white/light green wires on the coil + terminal. One wire has resistance & goes to the ignition switch. The other wire has no resistance & goes to the starter solenoid where it picks up full 12 volts during starting.
D
If your 75 is still stock, it uses a resistance wire in the harness & a 6 volt coil. There should two white/light green wires on the coil + terminal. One wire has resistance & goes to the ignition switch. The other wire has no resistance & goes to the starter solenoid where it picks up full 12 volts during starting.
D