Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
regularman
Yoda
Offline
Is it any good? Is it the best? How far does it cover? I,m looking to do both floor pans and the trunk(midget). How much will I need? Is it worth the money?
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
POR 15
- Thread starter regularman
- Start date
Share this page
I have used it a few times and it works great. as far as coverage that depends greatly on whether you spray it or brush it on. IMHO its very much worth it. Be sure to follow the directions carefully and if you have any left over that you wish to save, put a peice of plastic wrap between the can and the cover and store the can upside down.
roofinwilly
Senior Member
Offline
I swear be the stuff, it is the best and will last along time. $40 w/S&H is alot cheaper and less time consuming than new metal (which would be protected anyway).
One quart should produce two coats (barely).
Recommendation: disposable brushes and gloves, laquer thinner, work out of seperate container (tranfer with a clean coffee scoup), clean and place saran wrap over can before sealing top and always keep in freezer(not refridge). Be prepared to lightly prime before it sets up. Best of luck with the it!
One quart should produce two coats (barely).
Recommendation: disposable brushes and gloves, laquer thinner, work out of seperate container (tranfer with a clean coffee scoup), clean and place saran wrap over can before sealing top and always keep in freezer(not refridge). Be prepared to lightly prime before it sets up. Best of luck with the it!
Bruce Bowker
Obi Wan
Offline
Saran wrap over top of can before putting top on is very important as has been said. It is possible that if you get enough of the stuff in the rim and put the top back you won't get the top off again.