Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I wanted to make this post on hopes that it might help someone planning a restoration of their spridget. I had been researching plans to build a body otisserie so that I could strip and repaint the bottom of my BE. I found links to plans using two engine stands, one with 4x4 posts secured to rafters and one using a simple frame.
I decided to try the simple frame made of a 48"x48" piece of 3/4" plywood and 5 2x4s. Total cost was roughly $50. I spent around 2 hours today building the frame and mounting my stripped shell into it. I was able to flip the car on its side then onto its back by myselft with little effort.
I plan to post some pics for thos who havent seen one of these. Until then here's the link to the plans and original pictures.
https://www.gerardsgarage.com/GarageContent/rollover%20frame/rollover.htm
Ben in SC
I decided to try the simple frame made of a 48"x48" piece of 3/4" plywood and 5 2x4s. Total cost was roughly $50. I spent around 2 hours today building the frame and mounting my stripped shell into it. I was able to flip the car on its side then onto its back by myselft with little effort.
I plan to post some pics for thos who havent seen one of these. Until then here's the link to the plans and original pictures.
https://www.gerardsgarage.com/GarageContent/rollover%20frame/rollover.htm
Ben in SC
