Can anyone tell me if the early Longbridge BN4 cars originally had vinyl covered piping at the outside edge of the aluminum shut pillar finisher. This is the thin piping (about 1/8 inch) covered with black vinyl on later cars that goes between the outer edge of the finisher and the shut pillar. I have found contradictory information on this, and would like to know the answer before installing the aluminum finishers. If they had this, was it similar to the black vinyl covered piping in later cars?
A search of the 2019 Guidelines did not answer my question, and one discussion thread that I found appears to suggest that the early BN4 cars may be different in this than the later cars.
After first thinking that I had the wrong aluminum finishers for the car (after looking at my BT7), I found that the early Longbridge cars use an aluminum finisher that does not extend up as high as the later cars. To my relief, the new correct finishers for the car that I have appear to be correct.
A search of the 2019 Guidelines did not answer my question, and one discussion thread that I found appears to suggest that the early BN4 cars may be different in this than the later cars.
After first thinking that I had the wrong aluminum finishers for the car (after looking at my BT7), I found that the early Longbridge cars use an aluminum finisher that does not extend up as high as the later cars. To my relief, the new correct finishers for the car that I have appear to be correct.