Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Dgsndtrcks
Freshman Member
Offline
Has anyone installed a Pertronix on a BJ8, and if so, any advice?
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Pertronix Distributor
- Thread starter Dgsndtrcks
- Start date
Share this page
I had one for a few years. It was OK. You have to be careful which wires you use and don't leave the key in the "on" position without the engine running or it melts.
I sent my distributor to Advanced Distributors in Minnesota and went back to points 2 years ago. Won't do electronic again.
I sent my distributor to Advanced Distributors in Minnesota and went back to points 2 years ago. Won't do electronic again.
Wire-Wheels
Senior Member
Offline
I run one in my TR6. No problems. Of course it must be wired correctly, as is true with anything electrical. The thing I like is my timing is always spot on, so starting and performance is much more consistent. As with any electronics, they are subject to failure if they get too hot. [Yes, you should not leave the ignition key on without the engine running because it will overheat, but the same it true of OEM electronic ignitions as well]. Same is true of ignition coils. I run a very high output, aftermarket coil, mounted on phenolic washers to insulate it from the heat of the cylinder head. ...J.D.
Attachments
Offline
D--
I have Pertronix sets in both of my race cars and a Mallory Unilite in my Healey. Nothing is 100% bulletproof but I and many others like electronic ignitions for various reasons including simplicity and reliability. Yes you can burn them up if you leave the ignition key on but you can also burn up breaker points under similar circumstances.
Because condensers fail in strange ways and are usually replaced AFTER people have gone through and perhaps replaced the points--or even the coil--just getting rid of one component in the chain is a great plus for electronic ignitions.
All that said it is certainly not hard to change, adjust and maintain points and condensors--the choice is yours.
I have Pertronix sets in both of my race cars and a Mallory Unilite in my Healey. Nothing is 100% bulletproof but I and many others like electronic ignitions for various reasons including simplicity and reliability. Yes you can burn them up if you leave the ignition key on but you can also burn up breaker points under similar circumstances.
Because condensers fail in strange ways and are usually replaced AFTER people have gone through and perhaps replaced the points--or even the coil--just getting rid of one component in the chain is a great plus for electronic ignitions.
All that said it is certainly not hard to change, adjust and maintain points and condensors--the choice is yours.
Last edited: