• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

peco exhaust.

Share this page

N

NNN1947

Freshman Member
Country flag
Offline
Will i encounter any problems mounting a peco exhaust system to my 1979 MGB. I am not planning to remove the exhaust manifold. I do have a weber carb installed. Does that matter? The peco system has a 2 inch pipe.
 
So you are just using the rear section without the header as I read it. I just installed a Peco header and a used Ansa system. I had to have a connector pipe made to connect the 2 parts. The ansa system was on my other car and hooked up to a standard 1967 exhaust manifold and downpipe. The way you are going you may be able to get a reducer at a parts supply house and cut the downpipe or exhaust system to fit the length needed. I do not think its going to be a bolt up and go operation. I have a complete Peco system on my other car and it fit excellent but it did include the peco header. Good luck and welcome to the Forum. Bob
 
Back
Top