Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
SilentUnicorn
Yoda
Offline
Ok i have been reading here about blowing oil and all the other stuff. i have decided i should probaly place a pcv valve on my 79 1500. currently i have no place to get manigold vaccuum. my canon intake has a place all spot drilled and ready for drilling and tapping so i can get vaccuum.
Is this a good place?
what kind of pcv valve should i use? motor is desmogged and i don recall any pcv on the original set up
what i think i should do is drill and tap manifold, and place some sort of pcv valv in line to the breathe connection on the valve cover
any suggestions or advice?
Thanx
Is this a good place?
what kind of pcv valve should i use? motor is desmogged and i don recall any pcv on the original set up
what i think i should do is drill and tap manifold, and place some sort of pcv valv in line to the breathe connection on the valve cover
any suggestions or advice?
Thanx